These free bird house plans show you how to recycle an old license plate to attract a variety of birds. This simple birdhouse (nest box) can be made from a single board and a license plate and requires only a few tools to assemble. Find more diy bird houses plans or discover more bird houses and bird feeders.
Materials and Equipment Needed to Build this Simple Birdhouse
- Wood: 1″ x 6″ x 3′ (2.5cm x 15cm x 100cm)
- License Plate
- Screws: Approximately 1.5in” (4cm) long
- Power drill
- Hand saw
- Drill bit to match appropriate entrance hole size
Step 1. Cut the board using the birdhouse plans below.
Cut the 1×6 board as shown in the images below. Optionally sand all pieces smooth. Personally, I am using cedar. However, pine would also make a great choice.
Step 2. Drill the entrance hole for the birdhouse.
Drill a hole for the entrance using either a spade bit or forsnter drill bit. The plan above specifies a 1.5in (3.8cm) hole 4in (10cm) off the floor. A 1.5in (3.8cm) entrance hole is the optimum diameter for bluebirds and tree swallows. However, chickadees, nuthatches, warblers, woodpeckers, and wrens will also gladly make this their home. See Bird House Hole Size if you want to attract a specific bird.
Step 3: Pre-drill the holes.
Drill pilot holes to help prevent the wood from splitting. Ideally this hole should be at least as large as the screw’s minor diameter.
Step 4: Assemble the sides, floor, and back of the birdhouse.
Use a combination of glue and screws to attach the sides, floor, and back of the birdhouse together. A waterproof wood glue will help extend the life of the birdhouse. Personally, I recommend using stainless steel trim screws as shown below. The smaller screw head is less obvious and helps prevent the wood from splitting. If you pre-drill the holes, these screws will countersink themselves nicely because the head is not much larger than the pilot hole.
Step 5. Attach the roof to the birdhouse
First mark the center of the license plate as shown below. Next position this bend line over the straight edge of a table or work bench and bend down. Keep bending until the angle on the license plate matches the roof angle on the birdhouse. Attach the license plate to the birdhouse using only screws. This way, it can be later opened for cleaning. Find other ways to add a clean out door to your birdhouse.
Drill several 1/4″ holes in the floor for drainage. Also consider adding a perch to your birdhouse.
Step 6. Paint or finish your birdhouse.
In our case, we applied a linseed-oil. This finish helps accentuate the grain and helps make the wood more resistant to damage.
Step 7. Hang or mount your birdhouse.
Mount your birdhouse and see which bird will call your habitat home. See How to Hang a Birdhouse for the recommended mounting height for various birds. Your new birdhouse should provide you excitement for many seasons to come.
Building a bird box will encourage neighborhood birds to move in and raise families in your backyard. Hence providing you and your garden natural pest control.
Related Articles on Bird Houses, Bird Feeders & More
Use these free DIY bird house plans and bird feeder plans to attract bluebirds, chickadees, flickers, finches, house sparrows, kestrel, nuthatches, owls, purple martins, swallows, thrushes, warblers, woodpeckers, wrens, and other birds to your garden.